Industrial robot accuracy generally refers to repeatability and positioning accuracy, and in general repeatability is higher than positioning accuracy. Because repeat positioning accuracy depends on the accuracy of the robot's joint reducer and transmission, while positioning accuracy depends on the robot's algorithm, repeat positioning accuracy can be used to judge the quality of the robot's work.
1. Repetitive positioning accuracy
Repeat positioning accuracy refers to the deviation of the robot's position when it repeatedly reaches a point several times, i.e. the same position, the error between two positioning arrival positions. For example, if it is required to go 100mm, the first time it goes 100.01mm and the second time it repeats the action it goes 99.99mm, then the repeat positioning accuracy is 0.02mm.
2、Positioning accuracy
Positioning accuracy refers to the deviation between the indicated value and the actual value, that is, the error between the actual arrival position and the required arrival position, for example, the required walk 100mm, the actual walk 100.01mm, then the positioning accuracy is 0.01mm.
Factors affecting the accuracy standard of industrial robot bearings
1、Structural parameters design
The bearings of industrial robots have the requirements of long life, high rigidity and low friction, so when designing industrial robots, not only should we consider the largest possible dynamic load rating, but also need to carefully select the reasonable value of each structural parameter in order to improve the contact stress distribution of the bearing parts, achieve a contact state that is conducive to the formation of lubricating oil film and improve the service life of the bearings.
2、Groove position design
Industrial robot contact ball bearing inner and outer ring using the overall structure, and general cross-sectional area of only 20% of the same inner diameter standard bearings, so it causes the radial wall thickness of the cage to take a very limited value, if the groove position design in the centre of the bearing width, so that the bearing becomes a symmetrical structure, while the bottom of the cage pocket hole strength and seal installation position will be limited. Therefore, in order to ensure that the bearing cage has sufficient strength and the seal has sufficient installation space, the groove position is taken on both sides of the end face asymmetric design.
3、Height design of retaining edge
Industrial robot contact ball bearings in working condition, in a certain radial load at the same time also have to bear a certain axial load. If the axial load is too large, it may cause the steel ball and the inner and outer ring edge contact or the contact ellipse between the edge and the raceway to be truncated, which will produce stress concentration, the bearing collar will be worn, thus affecting the accuracy. Therefore, the design of retaining edge height needs to be based on the bearing bearing axial load size to project the bearing collar smaller retaining edge height, so as to calculate the collar retaining edge diameter. In the design of the contact ball bearing cross-sectional area is small, in order to meet the requirements of the premise, the high edge coefficient can be smaller than the deep groove ball bearing.
4、Sealing design
Industrial robot bearing damage is generally due to poor sealing, because the sealing is not good, air debris or other pollutants are easy to enter the bearing, so that the grease gradually failed, resulting in bearing damage, so the sealing of the bearing is critical. Therefore, when designing sealed bearings, both the seal and the specific working requirements of the bearing and the specific structural form of the bearing should be taken into account.

